PPC1-Diag>

Using PPCBug

26. Verifies the configuration data that is resident in NVRAM, and displays a warning message if the verification failed.

27.Calculates and displays the MPU clock speed, verifies that the MPU clock speed matches the configuration data, and displays a warning message if the verification fails.

28.Displays the BUS clock speed, verifies that the BUS clock speed matches the configuration data, and displays a warning message if the verification fails.

29.Probes PCI bus for supported network devices.

30.Probes PCI bus for supported mass storage devices.

31.Initializes the memory/IO addresses for the supported PCI bus devices.

32.Executes Self-Test, if so configured. (Default is no Self-Test.)

33.Extinguishes the board fail LED, if there are no self-test failures or initialization/configuration errors.

34.Executes the configured boot routine, either ROMboot, Autoboot, or Network Autoboot.

35.Executes the user interface (i.e., displays the PPC1-Bug>or

prompt).

3

Using PPCBug

PPCBug is command-driven; it performs its various operations in response to commands that you enter at the keyboard. When the PPC1-Bugprompt appears on the screen, the debugger is ready to accept debugger commands. When the PPC1-Diagprompt appears on the screen, the debugger is ready to accept diagnostic commands. To switch from one mode to the other, enter SD.

http://www.motorola.com/computer/literature

3-5

Page 71
Image 71
Motorola IH5, MCPN750A manual Using PPCBug