Motorola IH5 manual Remove the PMC filler from the front panel of the MCPN750A

Hardware Installation 1

!

Caution

Avoid touching areas of integrated circuitry; static discharge can damage these circuits.

5.Remove the PMC filler from the front panel of the MCPN750A.

6.Slide the edge connector of the PMC module into the front panel opening from behind and place the PMC module on top of the baseboard. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors (J11/12/13/14) on the MCPN750A.

7.Insert the four short Phillips screws, provided with the PMC, through the holes on the bottom side of the MCPN750A into the PMC front bezel and rear standoffs. Tighten the screws.

8.Reinstall the MCPN750A assembly in its proper card slot. Be sure the module is well seated in the backplane connectors. Do not damage or bend connector pins.

9.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source, and turn the equipment power on.

Note If the PMC provides rear I/O, refer to Chapter 7, Connector Pin Assignments for the pin assignments. Connectors on the TMCPN710 and TM-PIMC-0001 provide rear panel access to these signals.

http://www.motorola.com/computer/literature 1-23