Motorola IH5, MCPN750A manual Getting Started, Overview of Start-up Procedure, Startup Overview

Getting Started 1

Getting Started

This section provides an overview of the steps necessary to install and power up the MCPN750A, any additional equipment requirements, and a brief section on unpacking and ESD precautions. As identified in the table below, several steps can be omitted if your board, for example, has been shipped with PMCs and Flash already installed

Overview of Start-up Procedure

The following table lists the things you will need to do before you can use this board and tells where to find the information you need to perform each step. Be sure to read this entire chapter, including all Caution and Warning notes, before you begin.

Table 1-1. Startup Overview

Task	Section or Manual Reference	Page
Unpack the hardware.	Unpacking Instructions	1-5
Configure the hardware by	MCPN750A Baseboard Preparation and	1-6,1-11,
setting jumpers on the baseboard	TMCPN710 or TM-PIMC-0001 Transition Module	and 1-16
and transition module.	Preparation
Ensure CompactFlash card is	Compact Flash Memory Card Installation	1-6
installed (if required)
Install the PMC Module (if	PMC Module Installation	1-21
required)
Install the MCPN750A in the	MCPN750A CompactPCI SBC Installation	1-24
chassis.
Install the transition module in	TMCPN710 or TM-PIMC-0001 Transition Module	1-26
the chassis.	Installation
Connect any other equipment	Connector Pin Assignments	7-1
you will be using.
	For more information on optional devices and
	equipment, refer to the documentation provided with
	the equipment.
Power up the system.	Applying Power	2-1

http://www.motorola.com/computer/literature 1-3