Block Diagram
!
Caution
!
Caution
Use ESD
Wrist Strap
❏Do not disassemble, deform, or apply excessive pressure.
❏Do not heat or incinerate.
❏Do not apply solder directly.
❏Do not use different models, or new and old batteries together.
❏Do not charge.
❏Always check proper polarity.
Danger of explosion if battery is replaced incorrectly.
Replace battery only with the same or equivalent type recommended by the equipment manufacturer. Dispose of used batteries according to local regulations and manufacturer’s instructions.
Avoid touching areas of integrated circuitry; static discharge can damage circuits.
Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground. (Note that the system chassis may not be gro8unded if it is unplugged.) The ESD strap must be secured to your wrist and to ground throughout the procedure.
6 |
1.To remove the battery from the module, carefully pull the battery from the socket.
2.Before installing a new battery, ensure that the battery pins are clean.
3.Note the battery polarity and press the new battery into the socket.
Note When the battery is in the socket, no soldering is required.
4.Recycle or dispose of the old battery according to local regulations and manufacturer’s instructions.
http://www.motorola.com/computer/literature |
