Motorola MCPN750A, IH5 manual Installing a TMCPN710 or TM-PIMC-0001 Transition Module

1

Hardware Preparation and Installation

Installing a TMCPN710 or TM-PIMC-0001 Transition Module

The TMCPN710 or TM-PIMC-0001 Transition Module may be required to complete the configuration of your particular MCPN750A system. If so, perform the following install steps to install this board. For more detailed information on the TMCPN710 or TM-PIMC-0001 Transition Module refer to the corresponding users guide, i.e., TMCPN710 Transition Module Installation and Use (TMCPN710A/IH) or TM-PIMC-0001 Transition Module Installation and Use (TMPIMCA/IH) manual.

Installing PIMs on the TM-PIMC-0001 Transition Module

If PIMs have already been installed on the TM-PIMC-0001, or you are installing a transition module as it has been shipped from the factory, disregard this section, and proceed to the main installation section titled “Installing the Transition Module in the Chassis.” For PIM installation perform the following steps:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system.

3.Remove chassis or system cover(s) as necessary for access to the CompactPCI.

1-26 Computer Group Literature Center Web Site