
1 |
Hardware Preparation and Installation
Dangerous voltages, capable of causing death, are present in
! this equipment. Use extreme caution when handling, testing, Warning and adjusting.
4. Carefully remove the
5. Remove the PIM filler from the front panel of the
6. Slide the face plate (front bezel) of the PIM module into the front panel opening from behind and place the PIM module on top of the transition module, aligned with the appropriate two PIM connectors. The two connectors on the underside of the PIM module should then connect smoothly with the corresponding connectors (J10/J14 or J20/J24) on the
7. Insert the four short Phillips screws, provided with the PIM, through the holes on the bottom side of the
8. Reinstall the
9. Replace the chassis or system cover(s), reconnect the system to the AC or DC power source, and turn the equipment power on, or if hot swapping, you may now install the MCPN750A.
Installing the Transition Module in the Chassis
1.Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.
2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the chassis backplane.
Computer Group Literature Center Web Site |