![](/images/new-backgrounds/1248092/24809239x1.webp)
Before using the product for the fi rst time
USING DISHWASHER SALT
Filling the salt reservoir
In order to use soft water, you need to fi ll the salt reservoir with dishwasher salt.
CAUTION
CAUTION
Use dishwasher salt only.
Do not use any other type of salt or solvent. This may damage the salt reservoir and the water softening system.
Always fi ll the salt reservoir just before running one of complete washing programmes to prevent corrosion due to the excess salt or salty water.
1. Open the door.
2. Open the salt reservoir cap by rotating it counterclockwise.
3.Fill the salt reservoir with water (only required when switching on the appliance for the fi rst time)
4. Add the dishwasher salt.
The salt reservoir’s capacity is about 1 kg. Do not overfi ll the salt
CAUTION reservoir.
5. Remove excess salt from around the salt reservoir opening and cap seal.
If the excess salt is not removed, the salt reservoir cap may not CAUTION close properly and allow salt water fl ow out with negative impact to
the performance.
6. Rotate the salt reservoir cap clockwise until it is completely shut.
Recommended that if spilled a lot of salt or salty water to inside
Tub, run the Quick to clean inside Tub.
Any remaining salt grain or salty water can occur corrosion.
Depending on the size of the salt grains, it may take a while for the salt to dissolve and the “Lack of salt ” indicator to turn off.
Checking the Lack of salt indicator
If the “Lack of salt ” indicator is lit, add dishwasher salt as described above.
A lit “Lack of salt ” indicator means that there remains salt for three more cycles from the fi rst switched on.