Faulty components must only be replaced by original spare parts. Only when these parts are fi tted can the safety of the appliance can be guaranteed.
Always disconnect the dishwasher from the electrical supply for maintenance work (switch off at the wall socket and remove the plug).
If the connection cable is damaged it must be replaced with a special cable, available from the CAUTION manufacturer. For safety reasons, this must only be fi tted by the service department or an authorised
service technician.
In countries where there are areas which may be subject to infestation by cockroaches or other
WARNING vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the guarantee.
In the event of a fault or for cleaning purposes, the appliance is only completely isolated from the CAUTION electiricity supply when:
•it is switched off at the wall socket and the plug is withdrawn, or
•it is switched off at the mains, or
•the mains fuse is disconnected, or
•the
Do not make any alterations to the appliance, unless authorised to do so by the manufacturer.
Never open the casing/housing of the appliance.
CAUTION Tempering with electrical connections or components and mechanical parts is highly dangerous and can cause operational faults or electric shock.
While the appliance is under guarantee, repairs should only be undertaken by a service technician authorised by the manufacturer. Otherwise the guarantee will be invalidated.
When installing the product, make sure there is space at the top, left, right and back of the product to CAUTION ensure proper ventilation.
If there is insufficient space between the product and the sink, it may damage the sink or allow mold to grow.
Make sure that your dishwasher’s hardness level setting is correct as your area. (Refer to the “Water softener mode (Water hardness level setting)” section on page 18.)
01 SAFETY INSTRUCTIONS
