|
| Use this option when you want to dry your dishes more completely. | |
|
| The Dry+ option features a longer drying phase and higher temperatures in the | |
|
| last rinse cycle, resulting in improved drying performance with slightly higher | |
|
| power consumption. | |
|
| *Control Lock : This option allows you to lock the buttons on the control | |
|
| panel - except the Power button - so children cannot accidently start the | |
|
| dishwasher by pressing the buttons on the panel. Only the Power button | |
8 | Dry+ | remains active. | |
(Control Lock) | To lock or unlock the buttons on the control panel, press and hold the Dry+ | ||
|
(Control Lock) button for three (3) seconds.
•When the Power is On : Press and hold the “Dry+ (Control Lock)” button for three (3) seconds.
•When the Power is Off : Push the Power button fi rst, and then press and hold the “Dry+ (Control Lock)” button for three (3) seconds.
•Control Lock remains active until you turn it off. You cannot select cycles or options or start the dishwasher when Control Lock is on.
Displays cycle time and remaining hours and minutes, Delay Start hours, and check messages.
If an problem occurs during an operation, an check message is displayed with a warning sound.
Refer to the “Information codes” section on page 33.
Control Lock indicator
-Turns on if the Control Lock is set (or the dishwasher is in the standby or pause modes).
-Turns off while the dishwasher is operating.
-When Control Lock is on, the Control Lock indicator blinks for several seconds if any button except the Power button is pressed.
Self Clean indicator
-Turns on when the Self Clean option is enabled (or the dishwasher is
9 Display | in the standby or pause modes), but turns off while the dishwasher is | |
operating. | ||
|
-Blinks for 5 seconds every 20 to 22 cycles.
-The cycle counter disappears when the Self Clean operation is complete or when the dishwasher reaches the 23rd cycle without the Self Clean cycle being used. (The Reset or Self Clean operation is not counted by the cycle counter.)
Rinse Refill indicator
-Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in the standby or pause modes).
-Turns off while the dishwasher is operating.
Lack of salt indicator (*applicable models only)
-Turns on when the water softener runs out of salt. (or the dishwasher is in the standby or pause modes.)
-Turns off while the dishwasher is operating.
02 SETTING UP
