![](/images/new-backgrounds/1329876/32987639x1.webp)
3. If the PIN is correct, the system | |
announces | the day and time, then it |
announces | the number of new and old |
Remote Commands
Press #
messages. The system plays all new |
messages then beeps about once every |
then
To
two seconds to let you know it is ready |
to accept remote commands. |
Notes: |
• If the system does not respond, try |
entering your pin again. If you enter |
an incorrect PIN three times, the sys- |
tem beeps and hangs up. |
• When the system is in remote opera- |
tion, it stops all answering functions |
and rC appears in the message |
counter window. The system resumes |
answering functions when it is no |
longer in remote command if you |
have not turned it off. |
• The remote playback of incoming |
messages is limited to 4 minutes. If |
you have more messages after 4 min- |
utes have passed, you must press # |
2 again to listen to the rest of the |
messages. |
• When using remote operation, you |
can only delete the current message |
during playback. You cannot delete |
all the messages stored at one time. |
• The maximum length of a memo |
recorded by remote operation is 4 |
minutes. |
4. To use a remote command, press # and |
(within 2 seconds) the number for the |
command you want. |
Note: The remote operation stops when |
someone picks up the handset or any |
phone on the same phone line. |
1Repeat the current message during playback.
2Play messages.
3Skip current message during play- back.
4Delete current message during play- back.
5Stop playback, recording, and room monitoring.
6Set the system to answer calls.
7Record or stop recording a memo.
8Record or stop recording a new out- going message.
9Set the system to not answer calls.
Monitor the room where the system is located.
20 | Answering System Operation | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|