Radio Shack ET-1112 owner manual Memory Dialing, Storing a Number in Memory

43-1112.fm Page 12 Monday, September 13, 1999 5:08 PM

MEMORY DIALING

The ET-1112 can store three telephone numbers in speed dial memory, and you can dial any one of these numbers by pressing a single button. You can also store up to 20 more numbers that you can dial by entering a two-digit memory location number.

Storing a Number in Memory

Note: An error tone sounds and the phone exits the storing process if you wait more than 30 seconds between each key press.

1.Lift the handset.

2.Press MEM. The TALK/BATT indica- tor blinks.

MEM

3.Enter the number and any tone mode changes or pause entries (see “Entering a Pause”).

Notes:

•Each number you store can be up to 16 digits long.

•If you try to enter more than 16 digits, the phone sounds an error tone and exits the storing pro- cess. Start over from Step 2.

12

•Each tone or pause entry uses one digit of memory.

4.To assign the number to a speed dial button, press MEM, then press a speed dial button (M1–M3).

To store the number in a standard memory location, press MEM, then enter the two-digit memory location number (01–20).

The handset sounds a long beep to indicate that the number is stored.

5.For each stored number, write the person’s or company’s name next to the appropriate location number on the supplied memory directory sticker. Peel the backing off the sticker and attach it to the phone.

To replace a stored number, simply store a new one in its place.

To delete a stored number, lift the handset and press MEM twice, then enter the memory location number (01–20) or press the speed dial but- ton (M1–M3) you want to clear. The handset sounds a long beep to sig- nal that the memory location is clear.