If the wall plate has a single one-line phone jack, and there is a two-line phone jack nearby, plug one end of the supplied one-line short modular cord into L3, and plug the two-line long modular cord into LINE L1/L2.

Then plug the one-line short modular cord’s other end into the wall plate jack, and plug the two-line long modular cord's other end into the two-line wall jack.

4.Align the wall plate studs with the phone’s keyhole slots and slide

the phone downward to secure it. Then plug the adapter into a standard AC outlet.

10"#"9#.."

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit the keyhole slots on the bottom of the phone. Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 3/16 inch (5 mm) from the wall.

1.Place the flat end of the mounting bracket face up and insert the bracket’s four tabs into the matching slots on the bottom of the base. Then slide up and snap the bracket into place.

2.Repeat Steps 2 and 3 under “On a Desk” on Page 4 to connect the modular line cords and AC adapter. Then route both line cords to the right and middle slots and the adapter cord to the left slot on the mounting bracket.

3. Align the screws on the wall with the phone’s keyhole slots and slide the phone down to secure it.

4.Plug the phone cord(s)’

other end to the phone line jack(s) and plug the adapter into a standard AC outlet.

5

Page 5
Image 5
Radio Shack ET-1755 owner manual 10#9#