•The USOC number of the jack to be installed is RJ11W for a wall jack or RJ11C for a baseboard jack.
Caution: You must use a 120 VAC/12 VDC adapter that delivers at least 200 milliamps. Its plug must correctly fit the phone’s 12VDC jack. The supplied adapter meets these requirements. Using an adapter that does not meet these requirements could damage the phone or the adapter.
Placing the Base on a Desk Top
Follow these steps when you place the base on a desk, shelf, or table.
1.Plug one end of the supplied mod- ular cord into the TEL. LINE jack on the back of the base.
2.Plug the modular cord’s other end into a modular phone line jack.
3.Insert the supplied AC adapter’s barrel plug into the 12VDC jack on the back of the base.
4.Plug the adapter into a standard AC outlet.
5.Place the handset upright over the charging contacts on the top of the base (see “Charging the Bat- tery”).
Note: The phone will not charge if you try to use the charging con- tacts on the side of the base while it is flat on a desk top.
6.Fully extend the base’s antenna and place it in a vertical position.
Mounting the Base on a Wall Plate
You need a short modular cord (such as Radio Shack Cat. No.
1.Plug one end of the short modular cord into the TEL. LINE jack on the back of the base.
2.Route the short cord downward through the slot on the base’s bot- tom and under the clips as shown.
6