Radio Shack ET-547 owner manual Paging, Memory Dialing, Storing a Number in Memory

43-1047.fm Page 15 Tuesday, August 17, 1999 11:37 AM

PAGING

To page the person who has the hand- set or to locate the handset when the phone is not in use, press PAGE on the base. The handset beeps five times.

Storing a Number in Memory

Note: An error tone sounds and the phone exits the programming mode if you wait more than 20 seconds be- tween each keypress.

1.Lift the handset and press MEMO. The TALK/BATT LOW indicator blinks.

Note: The handset does not beep when the ringer is off.

MEMORY DIALING

This phone has three priority dialing memories. You can dial a number stored in any of these memories by pressing a single button. In addition, you can store up to 10 telephone num- bers in speed-dial memory, then dial a stored number by pressing a one-digit memory-location number.

Note: Each number you store can be up to 16 digits long.

2.Enter the number and any TONE and PAUSE entries. See “Storing a Tone Entry on a Pulse Line” and “Entering a Pause.”

Note: Each TONE or PAUSE entry uses one digit of memory.

3.If you want to store the number in priority dialing memory, press MEMO, then press a priority dial- ing button (P1-P3).

If you want to store the number in a speed-dial memory, press MEMO, then enter the memory location number (0-9).

A tone sounds to indicate that the number is stored.

4.To store more numbers, repeat Steps 1-3.

15