2.Press LINE 1 then lift the handset.
3.Dial one of your phone numbers. If the Line 2 indicator flashes, the number is connected to Line 2. If you hear a busy signal, the number is connected to Line 1.
After you confirm the phone number for each line, write the numbers on the number plate above the keypad. Use a paper clip to lift off the plate’s plastic cover. Use a pencil to write the numbers in case the numbers change.
Setting the Ringer Volume
To adjust the ringer volume, set RINGER to LO for a quiet ring or HI for a louder ring.
If you do not want the ringer to sound, set RINGER to OFF. You can still make and answer calls if you hear another phone on the same phone line ring or if you see a line indicator flashing.
4
OPERATION
To place a call, press the line button for an available line and lift the handset. When you hear a dial tone, dial the num- ber.
When you receive a call, that line’s indi- cator flashes. To answer a call, press the line button (LINE 1 or LINE 2) below the flashing line indicator and lift the handset. The line indicator turns off.
Line Indicator
The ring for Line 1 has a lower pitch than the ring for Line 2. This helps you tell which line is ringing.
To end a call, hang up the handset.
Adjusting the Handset Volume
Set the handset volume switch in the center of the handset to the desired lev- el (LO, MED, or HI).
Using Hold
To place a call on hold, press HOLD. The line’s indicator lights.
