Radio Shack 43-1090, ET-918, 43-1088/90 owner manual Connecting and Charging the Battery Pack

43-1088_90.fm Page 9 Tuesday, August 17, 1999 2:57 PM

8.Press and lift out the handset holder, rotate it 180°, then snap it back into place so it holds the handset.

9.Plug the adapter into a standard AC outlet. The POWER indicator on the base lights.

10.Lift the base’s antenna to a verti- cal position.

CONNECTING AND CHARGING THE BATTERY PACK

The phone comes with a rechargeable nickel-cadmium battery pack in the handset. Before using your phone, you must connect the battery pack and then charge it for about 14 hours.

1.Remove the screw on the battery compartment cover, then press down and slide the cover in the direction of the arrow to remove it.

2.Plug the battery pack’s plastic connector into the socket in the compartment. The connector fits only one way.

Note: For easier battery pack con- nection, lift it out of the compart- ment, insert its connector into the socket and replace the battery pack inside the compartment.

3.Replace the cover, then reinsert and tighten the screw.

To charge the battery pack, simply place the handset on the base. The CHARGE indicator on the base lights.

CHARGE Indicator

Recharge the battery pack when the handset beeps and the TALK/BATT LOW indicator flashes.

9