Radio Shack RS-4000 installation manual Mounting The Main Module, Installing The Status Indicator

49-840in.fm Page 12 Thursday, August 19, 1999 10:47 AM

3.Use pliers to squeeze down the tapping blade.

4.Close the insulated cover so it snaps.

MOUNTING THE MAIN MODULE

Select a location for the main module where it is completely concealed and difficult to access after installation. An ideal location is usually under and be- hind the vehicle’s dashboard on the firewall. Use two of the supplied wire ties to secure the main module under the dash.

INSTALLING THE STATUS INDICATOR

Use the supplied mounting bracket to hold the indicator or drill a hole in the dash. Follow these steps to install the indicator.

1.To use the supplied mounting bracket, use denatured alcohol to clean the surface and let it dry completely. Peel the backing off of one side of the double-sided tape and press it onto the bottom of the bracket. Then peel the adhesive backing from the other side of the tape and press the bracket onto the dash.

To mount the indicator in the dash, drill a 1/4-inch hole at the desired location. The surface should be less than 1/8-inch thick.

2.Press the supplied grommet into the mounting hole from the front of the surface.

GrommetIndicator

3.Press the indicator into the grom- ment from behind the surface.

4.Plug the indicator’s plug into the matching jack on the system.

5.Use a supplied wire tie to secure the wire out of the way.

12 Need Help? Call 1-800-598-2527