Radio Shack TAD-733 owner manual Using, Memory Dialing, Storing a Number in Memory

43-733.fm Page 16 Friday, September 17, 1999 8:57 AM

USING PAGE

To page the person with the handset or to find the handset, press PAGE on the base. The handset beeps twice for about 15 seconds.

To stop the handset from beeping be- fore it automatically stops, press TALK twice or press PAGE.

Note: Paging does not work during a call.

MEMORY DIALING

You can store up to 20 phone numbers in memory, then dial a stored number by pressing a two-digit memory location number.

Each stored number can be up to 16 digits long, including tone and pause en- tries.

Storing a Number in Memory

1.Press MEM on the handset. The TALK indicator flashes.

16

2.Enter the number and any tone or pause entries (see “Using Tone Ser- vices on a Pulse Line” on Page 15 and “Entering a Pause” on Page 17).

Notes:

•Each tone or pause entry uses one digit of memory.

•If you wait more than 30 seconds to press a key or enter more than 16 digits, the phone sounds one long beep. Start over at Step 1.

•To keep your accounts secure, we recommend you do not store your personal access code for services such as bank-by-phone in a memory location.

3.Press MEM, then enter a memory lo- cation number (01–20). A tone sounds to indicate that the number is stored.

To replace a stored number, store a new one in its place.

To clear a memory location (leaving it empty), press MEM twice, then press the memory location number you want to clear (01–20).