Ramsey Electronics HR40 manual Other Methods Of Dial Calibration, Direct Frequency Readout

OTHER METHODS OF DIAL CALIBRATION:

A easy way of making your own dial is to paste a small rectangle of paper behind the tuning dial knob. Then as you tune in different frequencies, pencil in on the paper the received frequency. Or a simple logging scale may be affixed behind the tuning knob on the front panel. A logging scale is simply a set of numbers for adjusting a control. For example, 4 might represent 7.1MHz and 5.5 being 7.12MHz, and so forth.

DIRECT FREQUENCY READOUT:

A novel advantage of the simple direct conversion receiver is that a general purpose frequency counter may be used to give a direct readout of the oscillator frequency. While you could experiment with an RF pickup loop or tuned circuit and counter preamplifier to boost the oscillator’s tiny output to a level suitable for the counter, the most reliable method is to wire a high- impedance counter probe line directly to pin 7 of the SA602, terminated to a rear panel frequency counter connection of your choice. This will consist of a short piece of mini-coax to a 1 megohm resistor bridged by a 27 to 33pF capacitor as shown below:

With the RF gain turned all the way up , it may be possible to hear the counter’s busy humming action in the background, but not to a serious degree. It drops out with a slight reduction of the RF gain. If you decided to add such a counter connection to your receiver, remember that the coax as well as the coupling capacitor become part of the oscillator circuit. Make the coaxial cable connecting the counter to the receiver as short as possible. You will experience a frequency change of several KHz when connecting or disconnecting the counter. Also, this additional capacitance in the oscillator circuit reduces the tuning range to approximately 100 KHz, thus offering another way of getting bandspread for your favorite frequencies. Finally, it may be necessary to operate the counter on battery power only; connection of an AC adapter might introduce considerable hum into the receiver.

THE LM386 AUDIO OUTPUT:

As already mentioned the LM386 is certainly capable of far more audio power output than is given in this basic receiver circuit. It can only boost what it gets directly from the SA602. There is certainly space on the HR40 circuit board to install an audio preamplifier (i.e. 2N3904, or minimum-gain LM386) in the circuit trace between C8, the audiocoupling capacitor from pin 4 of the SA602 to the volume control. The following is an audio preamplifier idea submitted by one of our customers. Ramsey Electronics in no way warrants that this modification will achieve any particular ideal signal-to-noise ratio or audio

HR40 • 22