Rangemaster CLAHDC120BC, LEIHDC60BB Fitting The Canopy Hood, Ducting, Installing The Chimney Hood

INSTALLING THE CHIMNEY HOOD

Note: If the hood is to be installed onto a hollow construction or plaster or partition board wall then special fixing screws will

be required (not supplied).

FITTING THE CANOPY HOOD

1.Rotate the adjusting screws (R) on the canopy (C) to about halfway.

2.Hook the canopy (C), onto the wall fixing bracket (1) and push down until the canopy adjusting screws (R) rest on the lugs.

3.To align or adjust the height of the canopy, use the two adjustment screws (R).

4.Before fitting the chimney to the canopy make the electrical connection as described in the section titled

“ELECTRICAL CONNECTION”.

5.When the electrical connection has been made, test the three speed fan

and worktop illumination.

DUCTING

The hood is more effective when used in the extraction mode (ducted to the outside). When used in the extraction mode ensure the ducting spigot has been correctly fitted.

When used in the extraction mode ensure the ducting spigot has been correctly fitted as illustrated opposite.

The ducting flange should be sleeved over the spigot when using 125mm (5ins) ducting

as the European ducting spigot is 120mm.

The ducting used must be125mm (5 ins), flexible or rigid and must be manufactured from fire retardant material, produced to BS.476 or DIN 4102-B1. The choice should be made by the installer. However, we recommend flexible ducting should only be used as an accessory as rigid ducting will provide better performance while reducing noise

levels.

When the cooker hood is ducted to the outside the charcoal filters must be removed.

12