Rangemaster RC90 manual Preheat Function

Note: The ‘+’ and ‘–‘ keys have a repeat function: holding a key pressed down will increase or decrease the power setting by one level every 0.3 seconds.

To shutdown a cooking zone:

Press the relevant ‘–‘ key to reduce the power to 0.

Rapid shutdown:

To quickly switch off a selected zone press the ‘+’ and ‘–‘ keys simultaneously: this will immediately switch off that zone (Fig.2-9).

Note: After a zone has been switched off an ‘H’ may appear in the display. This is a residual heat indicator showing that the cooking zone temperature is above 60°C and may still cause burns. Once the temperature has dropped to below 60°C the ‘H’ will go out.

To switch off all cooking zones:

All of the cooking zones can be immediately switched off by pressing the On/Off key. Any ‘hot ‘ zones that were in use will show an ‘H’ in the display (Fig.2-10).

Operating a double element:

Two of the cooking zones have dual elements and are controlled by the Dual Element key (Fig.2-11), which will toggle the setting on and off. To activate the dual element setting press the Dual Element key once (a light above the key will illuminate); press the key once again to switch off the dual element.

Operating the triple element:

The triple zone has three settings – dual, triple and off – and these are operated by successive operations of the key (Fig.2-12). Press the key once for the dual element setting (a single light will illuminate); press it once again for the triple element setting (two lights will illuminate) and press it again to switch back to a single element.

Fig.2-9

ArtNo.315-0021 RC90 Rapid shutdown

Fig.2-10

ArtNo.315-0022 R

����������������Fig.2-11

ArtNo.315-0023

������������������Fig.2-12

No.315-0024 RC90 Triple element key

Preheat Function

This function allows for rapid heating up of an element to bring a selected cooking zone up to temperature. The element will operate at full power until the cooking zone is at the required temperature then the power level will reduce automatically to the preset level.

To activate the preheat function:

The preheat is activated automatically by pressing the relevant ‘+’ key when selecting a cooking zone. A red ‘dot’ will illuminate on the selected display to indicate that the preheat is operating (Fig.2-13). Using the ‘–‘ key, set the preset power level. When the zone is up to temperature the dot will go out.

To adjust the preheat power level:

The preheat level can be adjusted by pressing the relevant zone controls: press the ‘+’ key to increase the power level and the ‘–‘ key to reduce the power level.

Fig.2-13

ArtNo.315-0025 RC90 Preheat indicat

�����������������������

5