Rangemaster RI77 Preheat Function, To shutdown a cooking zone, Rapid shutdown, 9, 10, 11, 12, 13

Note: The ‘+’ keys have a repeat function: holding the key pressed down will increase the power setting by one level every 0.3 seconds.

To reduce the power to a cooking zone select the required zone, as indicated by the red dot in the display. Press the ‘–‘ key to reduce the power required (Fig.2-8).

Note: The ‘–’ key has a repeat function: holding the key pressed down will reduce the power setting by one level every 0.3 seconds.

To shutdown a cooking zone:

Make sure the required cooking zone has been selected, as indicated by the red dot in the display. Reduce the power to

0 (Fig.2-9). After three seconds have elapsed the element will automatically switch off.

Rapid shutdown:

To switch off a selected zone press the ‘+’ and ‘–‘ keys simultaneously: this will immediately switch off that zone (Fig.2-10).

Note: After a zone has been switched off an ‘H’ may flash in the display. This is a residual heat indicator that shows that the cooking zone temperature is above 60°C and may still cause burns. Once the temperature has dropped to below 60°C the ‘H’ will go out.

To switch off all cooking zones:

All of the cooking zones can be immediately switched off by pressing the On/Off key. Any ‘hot‘ zones that were in use will show an ‘H’ in the display (Fig.2-11).

Preheat Function

This function allows for rapid heating up of the element to bring the selected cooking zone up to temperature. Once the zone is at the required cooking temperature the power level will reduce automatically to the preset level.

To activate the preheat function:

Select the required cooking zone. A red ‘dot’ will illuminate on the selected display to indicate that the zone has been selected.

1.Press the ‘–’ key to bring the element up to full power (Fig.2-12).

2.Press the ‘+’ key to activate the auto function, as indicated by the ‘A’ (Fig.2-13).

3.Use the ‘–‘ key to set the preset power level (Fig.2-14).

When the ‘A’ alternates with the selected power setting the preheat function is in operation.

To adjust the preheat power level:

Select the cooking zone (make sure the dot is illuminated) and then press the ‘+’ key to increase the power level. Pressing the ‘–‘ key after the preheat is underway will interrupt the operation, switching off the preheat and leaving the cooking zone operating at one power level lower.

Fig.2-9

ArtNo.317-0004 60 Reducing power

Fig.2-10

ArtNo.317-0005 60 Rapid switch off

Fig.2-11

ArtNo.317-0015 60 Switching the hob off

Fig.2-12

ArtNo.317-0006 60 Preheat

������������������������

Fig.2-13

ArtNo.317-0006 60 Preheat

���������������������������

Fig.2-14

ArtNo.317-0006 60 Preheat

������������������������������������

5