| Mounting the hood body |
|
• | Before attaching the hood body, tighten the two screws Vr lo- | Vr |
| cated on the hood body mounting points. | |
|
| |
• Hook the hood body onto the screws 12a. |
| |
• Fully tighten support screws 12a. |
| |
• | Adjust screws Vr to level the hood body. | 12a |
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer.
•To install a ø 125 mm air exhaust connection, insert the re- ducer flange 9 on the hood body air outlet and the adapting ring
•Fix the pipe in position using sufficient pipe clamps (not sup- plied).
•Remove any activated charcoal filters.
ø 150 | ø 125 |
10
9
RECIRCULATION VERSION AIR OUTLET
•Insert the connection extension pieces laterally 14.1 in connec- tion 15.
•Insert the Connector 15 into the Support bracket 7.3 and fix it with a screw.
•Make sure that the outlet of the extension pieces 14.1 is hori- zontally and vertically aligned with the chimney outlets.
•Connect the air outlet connection 15 to the hood body outlet
using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer.
• Ensure that the activated charcoal filters have been inserted.
7.3 | 14.1 |
| |
15 |
|
| ø 150 |
EN |
| 7 |
| 7 |
