Activated charcoal filter (Recirculation version)
The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes or at least every 4 months. The alarm signal will only light up when the extractor motor is swi- tched on.
Alarm signal activation
•In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date. Turn the Lights and the suction Motor off.
•Disconnect the Hood using the Main switch or the
•Restore the connection by pressing and holding T1.
•Release the button. All five LEDs are turned on.
•Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation:
-LED flashes twice - Activated charcoal filter saturation alarm ENABLED.
-LED flashes once - Activated charcoal filter saturation alarm DISABLED.
REPLACING THE ACTIVATED CHARCOAL FILTER
Alarm signal reset
•Switch off the lights and extractor motor.
•Press button T3 for at least 3 seconds, until the leds start to
flash.
Replacing the Filter
•Pull the Comfort Panel to open it.
•Remove the metal grease filters
•Remove the saturated activated carbon filter by releasing the fixing hooks
•Fit the new filter by hooking it into its seating
•Replace the metal grease filters.
Lighting
LIGHT REPLACEMENT
20 W halogen light.
• Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood.
• Extract the lamp from the Support.
•Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes.
•Replace the Support, fixing it in place with the two screws re- moved as above.
EN |
| 1 |
| 12 |
