GLOBUG SOLO LIGHTING SYSTEM — MAINTENANCE

Filter Replacement

WARNING - HOT SURFACE (LAMP FRAME)

DO NOT replace filter immediately, allow a sufficient amount of time for the lamp assembly to cool down before changing filter.

1.Remove the balloon as described in the "Removing the Lamp/Balloon" section.

2.Disconnect the lamp power cable (Figure 6).

3.Rotate the balloon/lamp base assembly so that the filter is facing upwards. See Figure 30.

Figure 30. Balloon/Lamp Placement

5.Install a new filter over the brace as shown in Figure 32. Be sure to align the cut of the filter over the brace.

Figure 32. Filter Placement

CAUTION - FILTER ALIGNMENT

When placing the filter element, always align the cut of the filter on top of the brace. This will keep the filter from being dislodged and getting damaged.

4.Turn the three locking tabs (Figure 31) inward to release the plate. Remove plate and filter.

6.Turn the three retaining tabs (Figure 33) outward so that they touch the lamp base.

Figure 33. Filter/Plate Install Figure 31. Filter Removal

GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09) — PAGE 23

Page 23
Image 23
Multiquip GB114BW manual Filter Replacement, Balloon/Lamp Placement