GLOBUG SOLO LIGHTING SYSTEM — SAFETY INFORMATION

GENERATOR SAFETY

If using a generator to power lighting system, refer to applicable generator manual safety information section.

ELECTRICAL SAFETY

DANGER

„Lighting system is equipped with a ground pin on the power plug. For your protection, ALWAYS complete the grounding path. NEVER insert the AC power plug into a 2-prong receptacle to operate lighting system.

When applying power to the lighting system, ALWAYS connect the AC power plug to a 3-prong receptacle that is grounded. The possibility exists of electrical shock, electrocution and even death if the lighting system is not grounded.

„ NEVER operate lighting system or handle any electrical equipment while standing in water, while barefoot, while hands are wet or in the rain. A dangerous electrical shock could occur, causing severe bodily harm or even death.

„ALWAYS make sure the area above

the lighting system is open and clear of overhead power lines and other obstructions. Contact with overhead power lines or other obstructions could result in equipment damage, electrical shock, electrocution and even death.

Power Cord/Cable Safety

DANGER

„NEVER let power cords or cables lay in water.

„NEVER use damaged or worn cables or cords. Inspect for cuts in the insulation

„ NEVER grab or touch a live power cord or cable with wet hands. The possibility exists of electrical shock, electrocution or death.

„Make sure power cables are securely connected. Incorrect connections may cause electrical shock and damage to the lighting system.

NOTICE

„ALWAYS make certain that proper power or extension cord has been selected for the job. See Cable Selection Chart in this manual.

PAGE 6 — GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09)

Page 6
Image 6
Multiquip GB114BW manual Globug Solo Lighting System Safety Information, „ Always make sure the area above