GLOBUG SOLO LIGHTING SYSTEM —TROUBLESHOOTING (LAMPS)
Practically all breakdowns can be prevented by proper handling and maintenance inspections, but in the event of a breakdown, please take a remedial action following the diagnosis based on the Lamp Troubleshooting (Table 4) information shown below.
If the problem cannot be remedied, please leave the unit just as it is and consult or company's service department.
TABLE 4. LAMP TROUBLESHOOTING
SYMPTOM | POSSIBLE PROBLEM | SOLUTION | |
|
|
| |
| Is plug disconnected? | Plug in correctly. | |
|
|
| |
| Is lamp power switched off? | Turn on switch. | |
|
|
| |
| Is lamp loose? | Screw lamp securely into socket. | |
|
|
| |
| Is contactor disconnected or loose? | Connect disconnected contactor. | |
|
|
| |
Lamp does not light. | Are any other electric appliances (other |
| |
than light tower) plugged into power | Unplug all other appliances. | ||
| |||
| source? |
| |
|
|
| |
| Is model of lamp incompatible? | Use genuine MQ lamp. | |
|
|
| |
| Is lamp not cool enough to light again? |
| |
| (Interval of 20 to 30 minutes is required | Wait for lamp to cool down. | |
| before turning on lamp again) |
| |
|
|
| |
Lamp only lights for a | Is ambient temperature too high (more than | Move lamp where there is proper | |
short time. | 104 °F (40 °C)? | ventilation. | |
|
|
| |
Balloon does not | Is fan motor (blower) not working properly? | Check or repair fan motor (blower). | |
|
| ||
inflate. | Is balloon envelope defective? | Repair or replace balloon envelope. | |
| |||
|
|
|
PAGE 26 — GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09)
