GLOBUG SOLO LIGHTING SYSTEM — MAINTENANCE
Ballast Box Removal
WARNING - HOT SURFACE (BALLAST)
Dangerous conditions exists inside the ballast compartment. Please use extreme caution when performing maintenance on the ballast box.
NEVER touch the ballast or ballast cover while the lamp is on.These components generate an
extreme amount of heat, which makes their surfaces very hot!. ALWAYS allow the ballast box and cover surface to cool down before servicing.
2.Disconnect the AC power cable and Lamp Power Cable from the ballast (Figure 31).
DANGER - HIGH VOLTAGE (BALLAST)
The electronic components of the ballast generate high voltage conditions. These conditions can be lethal and cause bodily harm, even death. When performing maintenance or troubleshooting, have only experience personnel work on the ballast.
Figure 31. Cable Disconnection
1.Remove cable clamp from the hook located under the balloon (Figure 30).
3.Unscrew and remove the knob bolt that attaches the ballast to the mast (Figure 32).
4.Unhook the bottom of the ballast from the slot on the mast and detach the ballast from the mast.
Figure 30. Cable Clamp
Figure 32. Ballast Removal
PAGE 22 — GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09)
