Rangemaster RMHDT110SS, RMHDT90SS Fitting The Telescopic Chimney, Installing The Chimney Hood

INSTALLING THE CHIMNEY HOOD

by pressing it downwards until the two pieces meet.

3.	Connect the two recirculation extension
	ducting pipes P1 on to the outlets on
	either side of the spigot R, which push	2.1
	fit into position, by pressing them
	horzontally until the two pieces meet.	2
4.	Do not fit the recirculation grilles until	8b
	after the chimney has been installed.	2.2

FITTING THE TELESCOPIC

CHIMNEY

The chimney stack consists of two sections.

1.To fit the upper chimney section S, first apply pressure to expand the two side panels slightly to allow the chimney to be fitted around the two brackets 2 as illustrated opposite. Fix the chimney to the two brackets 2 using four of the screws provided with the fixing kit.

2.To fit the lower chimney section I, first apply pressure to expand the two side panels slightly to allow the chimney to be fitted around the upper chimney S and the canopy C as illustrated opposite. Fix the chimney to the canopy C using two of the screws provided with the fixing kit.

3.To fit the two push-fit recirculation grilles G, insert them one at a time into the holes on either side of the chimney and apply slight pressure until they snap into position. Ensure the grilles are fitted correctly with one arrow pointing

upwards and one forwards.

4.When the hood is installed in the recirculation mode, ensure the recirculation grilles G, are properly secured to the inside of the recirculation ducting as illustrated opposite.

7.2.1

12c

8a

12c

14