Raypak 0133-4001 WH, NH manual Venting, Outdoor Installations

VENTING

OUTDOOR INSTALLATIONS

MODEL 133

Step 1: Remove the front (4) screws.

Step 2: Line up outdoor top vent opening over heater vent opening.

Step 3: Lower outdoor top onto unit lining up slots in the outdoor top with screws holes in jacket top.

Step 4: Reinstall (5) screws to secure jacket top and outdoor top to unit.

MODELS 514-824

Step 1: Lower outdoor "Stackless" top onto unit. Position top so it is centered on unit from side-to-side and front-to-rear.

Fig. #8114

MODELS 181-401 and 182-400

Fig# 8278.1

VENT TERMINAL (Outdoor) Stackless Top Installa- tion

1. Insert tabs into	2. Snap tabs into keyholes
keyhole (4 places).	so as not to pull out.

Pagoda Top (Shipped Loose with Heater)

Fig. #RP8280.1

Fig# 8166

Step 2: Tighten the (4) screws (Shown below) until they come in contact with the unit jacket top, then evenly tighten all (4) screws to secure to unit.

Fig# 8233

MODELS 926-1758

Heaters are shipped with outdoor vent terminal factory installed.

MODELS 2100-4001

These units are not certified for outdoor installa- tion.

11