Razor E100 owner manual Assembly and Set-Up, Attaching the Handlebars, Inflating the Tire

Assembly and Set-Up

qAttaching the Handlebars

Note: Make sure the cables/ wires are out of the way before inserting the stem into the fork.

(a)

1 Open the quick release.	2 Depress the push button (a)
	located on the front fork and
	insert the handlebar stem until
	the button locks securely into
	the fork.

3Adjust the tension of the quick release to where you can close the lever all the way to secure the stem.

qInflating the Tire

The front tire is inflated when shipped, but it invariably may lose some pressure between the point of manufacturing and your purchase.

1 Using a bicycle style tire pump equipped for a Schrader- type valve, inflate the front tire to the correct PSI indicated on the sidewall of the tire.

qCharging the Battery

Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use.

• Initial charge time: 18 hours	• Run time: Up to 40 minutes of continuous ride time
• Recharge time: up to 12 hours	• Average battery life: 250 charge/discharge cycles
When the scooter is not in regular
use, recharge the battery at least
once a month until normal use is
resumed.

Charger

Note: The pressurized air supplies found at gasoline stations are designed to inflate high-volume automobile tires. If you decide to use such an air supply to inflate the tire, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the excess pressure immediately.

WARNING: Always disconnect your scooter from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on

the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over- charge protection to prevent battery from being over-charged.

Charger

Plug

Charger Port

1 Turn power OFF before charging. Plug the charger into the charger port on the electric scooter.

2Plug the charger into a wall outlet. If the lights on charger do not light up, check the power to the outlet. If necessary, try a different outlet.

Charger will get warm during use. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.

WARNING: Failure to recharge the battery at least once a month may result in

a battery that will no longer accept a charge.

3