Razor E100 owner manual Repair and Maintenance

CONNECTORS/HARDWARE MAINTENANCE

q Brake

Check the brakes for proper function. When you squeeze the lever, the brake should provide positive braking action. When you apply the brake with the speed control on, the brake cut-off switch should stop the motor. Make sure that brakes are not rubbing.

Frame, Fork and Handlebars

q Check for cracks or broken connections. Although broken frames are rare, it is possible for an aggressive rider to run into a curb or wall and wreck and bend or break a frame. Get in the habit of inspecting your scooter on a regular basis.

q

q

Safety Gear

Always wear proper protective gear such as an approved safety helmet. Elbow pads and kneepads are recommended. Always wear athletic shoes (lace-up shoes with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels, motor and drive system.

Battery

Make sure the power switch is turned off whenever the scooter is not in use. Never store the product in freezing or below freezing temperatures! Freezing will permanently damange the battery.

q Tires

Periodically inspect the tires for excess wear, and regularly check the front tire pressure and re-inflate as necessary.

Do not use this product for the first time until you have inflated the front tire to the correct PSI and charged the battery for at least 18 hours. Failure to follow these instructions may damage your product and void your warranty.

Repair and Maintenance

Turn power switch “OFF” before conducting any maintenance procedures.

qAdjusting the Brakes

Tools required: 10mm wrench

1 To adjust the brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjust- ment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2.

2If brake is too tight or has too much slack, use a 10mm open wrench to loosen the brake cable and adjust accord- ingly.

3Inspect the brake pads (A) for proper alignment against the wheel or excess wear. To realign brake pads, loosen the fixing nut (B) and adjust the pad to contact the rim. Retighten and test. Readjust as needed.

Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.

4