ASSEMBLY AND SET-UP
❑Charging the Battery
Your electric scooter may not have a fully charged battery. Th erefore it is a good idea to charge the battery prior to use.
• I nitial charge time: 12 hours | • Run time: up to 40 minutes |
• Recharge time: up to 8 hours, | • Average battery life: 250 charge/discharge cycles |
Battery should be recharged |
|
a minimum of 8 hours after |
|
each use. When the vehicle |
|
is not in regular use, recharge |
|
the battery at least once a |
|
month until normal use |
|
is resumed. |
|
Always
disconnect your scooter from the charger before cleaning with liquid.
Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.
The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on
Charger
Port
Charger
Plug
1Plug the charger port into the port on the scooter. The charger works with the power switch in either the on or off position. The charging input, on/off switch and overload breaker are located under the deck at the front
2P lug the charger plug into a wall outlet.
the charger unit for the actual “charging” and “charged” status indications for your model charger.
C hargers have
Be sure to properly align the groove on the charger input plug with the corresponding
❑Attaching the Handlebars
socket on the case; otherwise, no charging action will occur.
WARNING: Failure to recharge the battery at least once a month may result in
a battery that will no longer accept a charge.
1Loosen the locking knob and swing to the 6 o’clock po- sition to unfold the handlebar.
4Using a 6mm hexagonal key wrench, tighten the wedge by turning the bolt clockwise. The wedge is properly tightened when the handlebars cannot be twisted out of alignment with the front wheel.
2Remove the plastic protector covering the base of the handle- bar assembly. Insert the “quill” part of the handlebar assembly into the fork. You may have to loosen the wedge to allow it to slip into the fork.
5Pivot the handlebar assembly upright.
3Slide the quill into the fork until it bottoms on the headset.
6Swing the locking knob to the 12 o’clock position and tighten by hand as firmly as possible.
WARNING: Failure to properly tighten the wedge may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.
WARNING: Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter, and make sure others are standing clear.
Note: The cable and wire assembly from the handlebar must not wrap around the steering tube or handlebar as shown in step 3. Sharp bends or twisting of the brake cable can cause the brakes to malfunction.
3
E_Series_Manualv10.indd 4 | 3/10/06 2:10:54 PM |
