Razor E300s, E325S, E200s, E125 Inflating the Tires, Use the special valve Align the access hole

REPAIR AND MAINTENANCE

❑Inflating the Tires

Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and

your purchase.

E200/E300 Rear Tire

1 Use the special valve	2 Align the access hole in	3 Remove valve adapter
extender/adapter supplied.	the drive sprocket with the	immediately after inflating.
The valve adapter is located	tire valve. Thread the adapter
in the bag with the owners	completely onto the valve and
manual supplied at the time	attach the pump. Inflate to
of purchase.	the PSI indicated on the tire
	sidewall.

E200/E300 Front Tire and E100 Tires

1Using a bicycle style tire pump equipped for a Schrader- type valve, inflate the front tire to the PSI indicated on the sidewall of the tire.

5

WARNING: Failure to remove the valve adapter after inflating will cause the inner tube and/or adapter to be severed by the rear drive sprocket.

Note: If you lose the adapter, a valve stem extender can be purchased at almost any auto parts store.

Note: The pressurized air supplies found at gasoline stations are designed to inflate high-volume automobile tires. If you decide to use such an air supply to inflate your electric scooter tires, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the excess pressure immediately.

E_Series_Manualv10.indd 6 3/10/06 2:10:59 PM