RCA ANT751 manual Insert end caps, Attach the mounting pipe to the foot

Make sure to place the leads of the matching transformer between the two washers on each post as shown here.

&INALLY TIGHTEN THE HEX NUTS TO SECURE THE LEADS

Step 6: Insert end caps

Insert the plastic end caps in the ends of the booms as shown here. Use a rubber mallet to gently tap them into the antenna booms to secure them.

Step 7: Attach the mounting pipe to the foot

21/2” screw

Hex nut on

5/8” bolt

&IND THE END OF THE MOUNTING PIPE WITH holes on the sides for screws. Insert this end into the middle of the foot as illustrated here. Then insert the 2-1/2” screw through the foot and pipe as shown. 3CREW THE v HEX NUT ONTO THE END OF THE screw to hold the pipe and foot together. Don’t tighten the nut completely yet.

&IND THE SQUARE HOLES ON EITHER SIDE OF the bottom of the pipe. Raise the pipe slightly and insert a 5/8” bolt through these holes and out of the side of the foot. Install the nuts on the outside of the foot on the 5/8” bolts to hold the pipe in place. Don’t tighten the nuts completely yet.