If the receiver is within the range, it beeps and PAGED appears for 30 seconds.
If PAGED does not appear, move the receiver closer to the transmitter and press PAGE again. If it still does not beep, repeat the steps under “Setting the System’s Identification Code” on Page 12 to verify that the identification code is properly set.
The receiver checks the range every three hours. If the receiver is out of the range of the transmitter, OUT OF RANGE appears. Move the receiver closer to the transmitter and press PAGE to check the range again.
Note: The transmitter can support an unlimited number of re- ceivers. The distance between receivers should be 2 feet or more to avoid interference.
SETTING THE DISPLAY CONTRAST, ALERT TONE, AND CLOCK DISPLAY FORMAT
1.Hold down SET and 9DOWN for about 5 seconds until
SETTINGS appears.
2.Press 9DOWN to set the display contrast (the default set- ting is 2).
3.Repeatedly press SET to select the contrast level
4.Press SET to toggle between BEEP ON and BEEP OFF, then press 9DOWN. The display shows the current clock format setting (the default setting is a
Preparation | 13 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
