References
Trouble Checks
Trouble | Checks and Adjustments |
Remote
Buttons don’t work when you press them
Remote lockup
Works part or none of the time
Press TV to set the remote to control the TV. See buttons on page 6.
Remove batteries and hold down one or more buttons for several seconds to drain the microprocessor inside the remote and reset it.
Clear the path between the remote and TV of any objects. Aim the remote at the component you are trying to control. Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 2.
Can’t select certain channel | Press number buttons. Channel may not be in memory. See Autoprogram |
| on page 19. |
| Make sure TV/VCR switch on VCR is in the TV position if using VCR. |
| For numbers over 100, press and hold 1 until |
| other two numbers. |
| Set Cable/Air feature to Cable for channels higher than 69. See page 24. |
TV Turns on or off
Turns off by itself
Turns on by itself
Does not turn off at Alarm Time
Check Sleep Timer. See sleep timer on page 21.
Wait 30 seconds and turn on again, a power surge may have occurred. Check Alarm Off time. See alarm clock on page 22.
Check Alarm On Time. See alarm clock on page 22.
Check clock time. See clock on page 3.
Make sure alarm is turned on or off. See alarm clock on page 22. Check clock time. See clock on page 3.
Make sure Clock time is set correctly, including AM and PM. Check Alarm Off time.
28
