RCA DRC105N manual Connections and Setup, Things to consider before you connect

Chapter 1 Connections and Setup

Things to consider before you connect

Protect components from overheating

•Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

•Don’t stack components.

•When you place components in a stand, make sure you allow adequate ventilation.

•If you connect an audio receiver or amplifier, place it on the top shelf.

Position cables properly to avoid audio interference

•Insert each cable firmly into the designated jack.

•If you place components above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the back of the TV.

•If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away from audio/video cables.

Note: Some discs may not be compatible due to laser pickup and disc design.

Install Batteries in the Remote

1 2 3

1.Remove the battery compartment cover.

2.Insert the batteries (provided), by matching the diagram in the battery compartment to make sure + and – are in the proper position.

3.Put the battery cover back in place.

Important Battery Information

•If you’re not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.

•Dispose of batteries in the proper manner, according to federal, state, and local regulations.

•Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.

•Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.

4