Connections and Setup
Connection: DVD + TV + VCR
1.Connect the audio cables to the AUDIO OUT L (left – white) and R (right – red) jacks on the back of your DVD Player, and to the corresponding Audio Input jacks on your TV (sometimes labeled AUDIO IN L and R).
2.Connect the video cable.
2a. Basic video connection – Connect the video cable (yellow) to the VIDEO OUT jack on
the back of your DVD Player, and to the Video Input jack on your TV (sometimes labeled VIDEO IN).
–OR –
2b.
– OR –
2c. If your TV has component video jacks (Y, Pb, Pr) jacks, use
Note: If your TV or monitor has progressive scanning capability, you need, to make sure you choose correct setting on the back of the DVD Player (step 6 below).
3.Connect the antenna or cable to the Antenna Input jack on the VCR (sometimes labeled IN FROM ANTENNA).
4.Connect a coaxial cable to the Antenna Output jack on the VCR (OUT TO TV) and to the Antenna Input jack (CABLE/ANTENNA) on the TV.
5.Insert the AC power cord into an AC outlet.
6.If your TV is capable of using progressive scanning and you connected the DVD Player to the TV by connecting the Component Video Jacks (Y, Pb, Pr), make sure you change the Video Selection switch setting to PROGRESSIVE SCAN ONLY position on the back of the player. All other connections should leave the Video Selection switch set to NORMAL connections (VIDEO,
Go to page 8
9