Connections & Setup
3. Highlight the channel to which you have to tune your TV in order to see cable programming, and press OK (a screen appears reminding you to connect your G- LINK cable to your TV and cable box).
Notes: Channel 03 is the most common.
Choose Video1/AUX if your cable box is connected to your TV with audio/video cables instead of a coaxial cable. Go to page 7 for pictures of these cables.
4. Highlight your brand of cable box, and press OK.
If your brand isn’t listed, highlight Not Listed and press OK.
| 5. Make sure your cable box is on. |
| Tune the cable box to channel 02 (use the remote |
| control that came with your cable box, or press the |
| channel buttons on the cable box). |
| Press OK (the GUIDE Plus+ system starts testing |
| codes). |
| Important Note: When code testing is in |
| progress, don’t touch your TV, VCR, cable box |
| or any of the remote controls for these |
| products. |
| 6. Look at your cable box. If it is still on and changed to |
| channel 09, the test was successful. Highlight Yes, |
| and press OK (STEP 3: Configuring for a VCR |
| appears). |
| If your cable box didn’t change to channel 09 or |
| turned itself off, you have two choices: No and Test |
| this code again. |
| Test this code again: If you think the TV, the |
| cable box, or any of the remote controls might |
| have been touched or bumped during the test, |
| highlight Test this code again and press OK (the |
| GUIDE Plus+ system runs the same set of codes). |
| No: If you don’t think the test was interrupted, |
| highlight No and press OK (GUIDE Plus+ system tests |
| the next code). |
| Repeat the previous instructions until the TV finds the |
| correct cable box code. Follow the instructions on the |
| screen. |
| Note: If the TV can’t find your cable box |
| code, a troubleshooting checklist appears. |
| Carefully review each checklist and follow |
| the instructions on the screen. |
|
|
16 | Chapter 1 |
1571963A.01 Setup | 16 | 4/9/02, 12:58 PM |
