SETUP AND CONNECTIONS
STEP 1: UNPACK THE TV
Make sure to locate the remote control.
STEP 2: CONNECT YOUR TV
There are three types of connections outlined in this section:
TV Only: | If you’re only going to connect the |
| TV to your home antenna or cable |
| system. |
The Basic Connection: | If you’re going to connect the TV to a |
| VCR or satellite receiver. |
Advanced Connections: | If you’re going to make multiple |
| connections, hooking up the TV to a |
| VCR and a satellite receiver. |
Cable information and illustrations are given for each type of connection. Once you have completed your desired connection you may skip forward to Step 3.
TV ONLY
This is a basic connection from an antenna or cable system to your TV. Connect the cable into the Cable/Antenna jack as shown.
Cables
You will use the following cable to make your connection:
Coaxial Cable: These cables carry audio and video signals to the TV from an antenna, cable, or cable box.
CABLE, CABLE BOX, OR ANTENNA
TV |
|
|
|
| SPEAKER | + RIGHT - | + LEFT - |
| SELECTION | ||
| EXTERNAL INTERNAL |
| |
| SPEAKERS |
|
|
| INPUT 2 |
| |
INPUT 1 | VIDEO | ||
VIDEO |
|
| |
|
|
| |
R | R |
|
|
AUDIO | AUDIO |
| CABLE/ |
L | L |
| ANTENNA |
|
|
| INPUT |
AUDIO OUTPUT |
| ||
|
|
Once you have completed this connection you may skip to Step 3.
Important Stand Information
CAUTION: Choose the location for your TV carefully. Take precautions that the stand or other furniture on which the TV is placed is properly located (see Important Safeguards sheet) and of adequate size and strength to prevent the TV from accidentally being tipped over, pushed off, or pulled off. This could cause damage to the TV and/or personal injury.
Before You Connect
Protect against power surges:
•Connect all components before plugging any power cords into the wall outlet.
•Turn off the TV and/or component before connecting or disconnecting any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV.
4