RCA HD50LPW167 manual Clearing a Learned Function, Deleting ALL Learned Functions

Using the Remote Control

1.Press and hold the device button on the TV’s remote that applies to the function you will be adding (DVD, VCR, SAT/CAB, AUDIO, or AUX). The device button lights.

2.On the TV remote, press and hold the RECORD button.

3.Keep pressing both of the buttons (the device button and the RECORD button) until the device button light turns off, flashes, and turns off. Release both buttons.

4.On the TV’s remote control, press and release the button where you want to store the new function (the device button turns off and then back on).

Note: If you press an invalid button on the TV remote, the device button flashes 4 times to alert you. You’ll have to repeat step 4.

5.With the remote controls facing each other and no more than 2 inches apart, press and hold the button of the device’s remote control that has the functionality you are recording to the TV’s remote control. Keep pressing the button until the TV remote’s device button light turns off and back on (the function has been saved to the TV remote). If all device buttons flash 4 times, the function wasn’t learned. Try again starting with Step 4.

6.The TV remote control remains in “learning mode” so you can continue adding functions to different buttons by repeating steps 4 and 5. Or, press CLEAR to exit learning mode.

Notes: If you want a new function on a button, you must record (learn) over it.

The amount of memory each learned function uses in the TV’s remote control varies. If your TV remote is out of memory, the device button(s) light flashes 4 times and turn off, exiting you from the Learning mode.

Clearing a Learned Function

To delete a learned button function, use the procedure below.

1.Press and hold the device button (the device button lights). Then press and hold the CLEAR button for 3 seconds. Continue depressing both buttons (the device mode button flashes—turns on and off again).

2.Release the device and CLEAR buttons (the device button being programmed turns on). Remote is now in Clear learned function mode.

3.Press and release the button where learning is to be cleared. The device button blinks off then back on—the learned function was cleared successfully.

4.Repeat steps 1 through 3 until all buttons’ learned functions have been cleared.

Note: If an invalid button is pressed, the device mode button(s) flashes 4 times and the selected device button stays on and remote remains in Clear Learned Function mode. Repeat step 3.

5.Press the CLEAR button and your TV remote returns to its original operation mode.

Deleting ALL Learned Functions

This procedure erases all learned functions in every device mode of the remote.

1.Press and hold the CLEAR button (the current device button lights). Then press and hold the ON•OFF button (device button light turns off for 3 seconds, flashes, turns on and off) while continuing to hold

CLEAR.

2.Release both buttons (current device button turns on).

3.Press any device button to delete all learned functions in all modes. Remote is automatically exited from this mode.

Note: Pressing the CLEAR button will NOT delete all learned functions, but will exit the Delete mode.

Chapter 2 39