RCA HDLP50W151 manual How to Connect TV + Satellite Receiver + VCR

Connections & Setup

TV

Satellite Receiver

VCR

VCR

VIDEO	L	AUDIO	R
ANTENNA IN
OUT
VIDEO	L	AUDIO	R
IN
ANTENNA OUT

SATELLITE

RECEIVER

VIDEO L AUDI R S-VIDEO

OR

OFF-AIR ANTENNA

	3
	RIGHT	LEFT		FIXED/VARIABLE							TV
					AUDIO
					OUTPUT		CENTER CHANNEL INPUT
			SPEAKER			INTERNAL		EXTERNAL AMPLIFIER
								MAXIMUM POWER RATING!
			SELECT			SPEAKER		(60 WATTS into 8 OHMS)
				INT W/	R	SOURCE
			EXT	EXT		TV	EXT AMP
				SURR
	EXTERNAL SPEAKERS				L
	VIDEO			VIDEO		VIDEO		VIDEO
	INPUT 1			INPUT 2		INPUT 3		INPUT 4
	V		V			V	PR	V	PR		VIDEO
											INPUT 5
		S-VIDEO		S-VIDEO							DVI-HDTV
2A	L/MONO		L/MONO			L/MONO	PB	L/MONO	PB	L/MONO
	R		R			R	Y	R	Y	R
	AUDIO		AUDIO			AUDIO		AUDIO		AUDIO
	INPUT 1		INPUT 2			INPUT 3		INPUT 4		INPUT 5
	RECORD
	OUTPUT
	VIDEO
							ANTENNA B			ANTENNA A
								INPUT		INPUT
	AUDIO	DIGITAL
		AUDIO					ETHERNET
	R	OUTPUT
2B	L		G-LINK

CABLE

1

Connect G-LINK Cable (see page 23)

How to Connect: TV + Satellite Receiver + VCR

1.Connect your cable or off-air signal to ANTENNA A.

If you have cable and an off-air antenna, connect the cable signal to ANTENNA A INPUT (antenna A is the only source for the GUIDE Plus+ system). Connect the off-air antenna to ANTENNA B INPUT. If you have only an off-air antenna, connect it to ANTENNA A INPUT.

2.Connect your VCR to your TV.

A.Connect the VCR’s audio/video outputs to INPUT 1 (audio/video) on the TV using composite audio/video cables.

B.Connect the VCR’s audio/video inputs to RECORD OUTPUT on the TV. This enables recording of digital programs (unless copy protected, using DVI HDTV or component video formats), as well as analog programs.

3.Connect your Satellite Receiver to your TV.

Connect the satellite receiver’s audio/video output jacks to the INPUT 2 AUDIO (R and L) and VIDEO jacks on the TV using composite cables. If your satellite receiver has an S-Video output, you can make the video connection by using the S-VIDEO jacks instead. If your satellite receiver has component outputs, then use INPUT 3 or 4.

Note: If you are using an S-Video cable or component video cables, you must also use audio cables. The S-V ideo cable and component video cables only transfer video information.

Viewing the Components

1.Turn on the TV and the component(s) you want to view.

2.Press the TV button on the remote control.

3.Press the INPUT button on the remote control to scroll through the Video Input Channels.

•The VCR can be viewed on the INPUT 1 channel.

•The satellite receiver can be viewed on the INPUT 2 channel.

Note: You can set up the TV to automatically tune to the correct Video Input Channel. This is called Auto Tuning. (See Chapter 3 for more information.)

Go to page 23

Chapter 1 11