RCA IP900 manual TV + A/V Receiver + IP Decoder + Modem, Connect the A/V Receiver to your Decoder

Chapter 1: Connections and Setup

TV + A/V Receiver + IP Decoder + Modem

1.Connect the Decoder to the TV

A.Connect the video cable to the VIDEO OUT jack (yellow) on the back of the decoder and the other end of the cable to the corresponding input jack on the TV (sometimes labeled VIDEO).

B.If your TV doesnÕt have a video input jack, you need to use an RF modulator (not included). Connect the three-pronged end of the modulator cable into the AUDIO OUT L, RF MOD, and VIDEO jacks on the back of the decoder. Then use a coaxial cable to connect the Out to TV jack on the modulator to your TVÕs antenna in jack (sometimes labeled CABLE/ANTENNA).

Note: If your TV has an S-Video input, we recommend you make the video connection by using this jack instead. Remember to connect audio cables for this connection as S-Video only carries the picture signal, not the sound.

2.Connect the A/V Receiver to your Decoder

A.Connect audio/video cables to the AUDIO OUT R and L jacks on the back of the decoder (color coded, red and white). Connect the other ends of the cables to the corresponding input jacks on your A/V receiver (sometimes labeled VIDEO, AUDIO L/MONO, and AUDIO R). You may also want to connect video to your receiver (or TV using instructions on the previous pages).

–OR –

B.If you have an audio/video receiver with Dolby* Digital or a digital optical jack, remove the protective cap from the OPTICAL DIGITAL AUDIO OUT jack on the back of the decoder (if necessary) and also remove the protective caps from your digital optical cable.

Connect one end of the digital optical cable to the OPTICAL AUDIO OUT jack on the back of the decoder and the other end to the corresponding input jack on your A/V receiver (sometimes labeled OPTICAL IN). You may also want to connect video to your receiver (or TV using instructions on the previous pages).

3.Connect the ethernet cable to the IP Decoder

Connect one end of a standard CAT-5 ethernet cable (not included) to the ETHERNET jack on the modem and the other end to the ETHERNET jack on the decoder.

4.Connect the DSL line to the DSL Modem

Connect the DSL line from the wall jack to the DSL LINE IN jack on your modem.

5.Plug the power supply into the IP Decoder power jack and into an AC outlet.

Go To Page 10

*Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

Chapter 1 Illustrations contained in this document are for representation only. 9