Chapter 4: Additional Information
How to Find Your TV’s Video Input Channel
You must tune your TV to the video input channel if you are using the IP video decoderÕs Audio/Video (A/
V)OUT jacks to connect to the TVÕs A/V input jacks. You must select the TVÕs video input channel before you can see the decoderÕs menus or programming.
The video input channel for TVs varies by brand and model. Below are some steps to try to find your TVÕs video input channel:
AUX | ON • OFF | TV |
|
VIDEO | WEB EMAIL | VOD |
|
MUTE | CH + | HOME |
|
|
|
| |
VOL |
| VOL | TV button |
|
|
|
CH -
GUIDEMENU
KEYBD TOOLS INFO
OK
SELECT
BACKEXIT•CLEAR
1 
2 
3
4 
5 
6
7 
8 
9
AUDIO•INPUT ANTENNA 0
REV•REPLAY PLAY FWD•SKIP
RECORD STOP PAUSE
AUDIO• INPUT button
If you programmed your remote control to operate your TV (instructions on page 14), and you are using audio/video jacks, press the AUDIO¥INPUT button to find the Video Input Channel.
¥If your TV brand is RCA, GE, or Proscan, press the TV button on the decoderÕs remote control, then press the AUDIO¥INPUT button.
¥If you have another brand of TV, see page 14 to see if the decoderÕs remote can be programmed to control your TV. If so, once completed, follow the step above.
If those options do not work, try the following ideas. You might access the video input channel by:
¥Pressing a button on the TVÕs remote control (see the table below).
¥Selecting a specific channel from the TVÕs
¥Tuning directly to the video input channel by selecting a specific channel number (see the table below)
¥Going through all available channels by pressing the channel up or down buttons on the TV or its remote control.
Video Input Channel Variations
Button/Switch | Button on the | Channel |
on the TV | TV Remote | Number |
VIDEO | VID 1 | 00 |
SIGNAL | LINE | 90 |
VID 1 | VID | 91 |
VID 2 | VIDEO | 92 |
93 | ||
INPUT | VID 1 | |
| VID 2 | |
| SOURCE |
|
| AUX |
|
26 | Illustrations contained in this document are for representation only. | Chapter 4 |
