![](/images/new-backgrounds/1149767/149767113x1.webp)
HOW TO USE THE FAX FUNCTION
When placing the Original on the document glass:
1 Confirm that there are no original(s) in the RADF, and open the RADF.
2 Place the original face down on the document glass. Align the original according to the original scale in the illustration below. (Line up the center of the edge of the original with the
( ) mark.)
Original scale
mark
3 Gently close the RADF.
Note | When using the document glass, do not set | |
original(s) in the RADF. | ||
|
4 If needed, set the original size (p.54), resolution (p.55), and contrast (p.55). Continue with the "DIALING AND TRANSMITTING" (p.59) section.
5 Press the [START] key ( ).
The set original size appears in the display and then scanning begins.
Note | After the [START] key ( | ) is pressed, the |
set original size appears in the display. |
(EX. )
READING #001
8.5x11 100%
Make sure that the displayed size is the same as the actual original size. (The factory default setting for the original size is "8.5x11".) If the displayed size is not correct, press the [CLEAR ALL] key () to stop operation and then change the original size setting. (See "ORIGINAL SIZE" (p.54))
When faxing from the document glass, if the 4 size of the original is different from the
specified size, part of the image may be cut off.
6 If you have more than one original to read into memory, place the next page, and press the [START] key ( ) to read each page.
Go to step 7 after the last page has been scanned.
7 Press the [#] key.
Transmission begins.
53