Using the Remote Control
Programming the Remote
ON•OFF
TV | PIP |
SAT•AUX | DVD |
GO BACK | |
VOL | CH |
| MUTE |
| INFO |
MENU | + CH CTRL |
ZOOM- | ZOOM+ |
CLEAR | GUIDE |
| PRESETS |
There are three ways to program the remote control to operate other devices: Direct Entry, Manual Code Search, and Automatic Code Search. If you have recently purchased the device you want to control or if the device has many codes, you might want to try the manual code search first.
Using Direct Entry
1.Turn on the device you want to control.
2.Look up the brand and code number(s) for the device in the code list at the end of this section.
?!+- |
| DEF | |
| ABC |
| |
GHI | JKL | MNO | |
|
| ||
PQRS | TUV | WXYZ | |
INPUT | SUB CH | ||
_,.:=$ |
You’ll use these darkened buttons for Direct Entry.
Using Manual Code Search
3.On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds) until a device button remains lit. Then release the buttons.
4.Press and release the device button (SAT•AUX or DVD) you want to program.
5.Enter a three digit code from the code list.
6.To test the code you’ve programmed for that device button, point the remote at the device and then press ON•OFF to see if the device responds to the remote control.
If the device turns off, you’ve entered the correct programming code for your device. Circle the code you entered for future reference.
If the device doesn’t turn off, repeat these steps until you’ve tested all codes for your device’s brand or try to run a manual code search.
Note: Before using manual code search, you must use Direct Entry first. This lets the remote know which type of device to begin searching codes. Then proceed with the following steps.
1.Turn on the device you want to control.
2.On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds) until a device button remains lit. Then release the buttons.
3.Press and release the device button (SAT•AUX or DVD) you want to program.
4.Repeatedly press and release the ON•OFF button, watching for the device to respond. If it does turn off, press and release the OK button within 3 seconds to save the code. If you accidentally passed the code before saving it, press the left arrow button to backtrack through the codes; then use the right arrow button to go forward through the codes again.
When all codes have been searched, the device button flashes 3 times, then the remote exits manual code search and returns to normal operation.
Using Automatic Code Search
1.Turn on the device you want to control.
2.On your remote control, simultaneously press and hold ON•OFF and MUTE (approximately 3 seconds) until a device button remains lit. Then release the buttons.
3.Press and release the device button you want to program.
continued on next page...
20 | Chapter 2 |
