RCA LED46C45RQ warranty LED LCD TV User’s Manual

Part No.: RN0346R0117

English

LED LCD TV User’s Manual

Model Number.

LED46C45RQ

Table of Contents		Child Safety Guide
Child Safety Guide	1
Caution and Warning	2
FCC Notice	2
Safety Precautions	2
Preparation for Your New TV	3
Check Accessories	3
Setup TV Table Stand	3
Select TV Location	3
Connection and Using	3
TV Stand Installation	3
TV Signal Connection	4
Cable Connections	4
Side Panel Connections	4
Connecting AV Composite Video device	4
Connecting YPbPr Component device	5
Connecting HDMI device	5
How to Obtain Various Kinds of Input Sources	5
TV Jacks Explanation	5
Keypad and Front Panel	6
Panel Buttons	6
Front Panel	6
Remote Control Instructions	6
Inserting Batteries in the Remote	6
Remote Control Reception Angle	6
Learning about Remote Control	6
Remote Control Buttons	6
Initial Setup	7
Basic Operations	7
Turning On and Off	7
Choosing TV Channel	7
Selecting Input Source	7
Channel Bar	7
Adjusting Volume	7
...........................................

Use una montura que se ha recomendado por el fabricante de monitor y/o listado por un laboratorio independiente (como UL, CSA, ETL).

Siga todas las instrucciones ofrecidas por el fabricante de monitor y montaje de pared.

Caution and Warning

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION:

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE WITH THE FCC RULES COULD AVOID THE USERS AUTHORITY TO OPERATE THIS EQUIPMENT.

FCC Notice

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio Communications. However, there is no Guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and the receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Safety Precautions

1.	Read these instructions.
2.	Keep these instructions.
3.	Heed all warnings.
4.	Follow all instructions.
5.	Do not use this apparatus near water. For example, do not use
	near a laundry tub, in a wet basement, or near a swimming pool,
	and the like.
6.	Clean only with dry cloth.
7.	Do not block any ventilation openings. Install in accordance with the
	manufacturer’s instructions. Slots and openings in the cabinet back
	or bottom are provided for ventilation, to ensure reliable operation
	of the TV and to protect it from overheating. These openings must
	not be blocked or covered. The openings should never be blocked
	by placing the TV on a bed, sofa, rug, or other similar surface.
8.	Do not install near any heat sources such as radiators, heat
	registers, stoves, or other apparatus (including amplifiers) that

as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the appratus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.This TV should be operated only from the type of power supply indicated on the rating label. If customer is not sure the type of power supply in your home, consult your appliance dealer or local power company. For TV remote control battery power, refer to the operating instructions.

16.The TV set shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the TV set.

17.Never push objects of any kind into this TV through openings as they may touch dangerous voltage or other electrical parts that could result in fire or electric shock. Never spill liquid of any kind into the TV.

18.Unplug the TV from the wall outlet before cleaning. Do not use liquid or aero cleaners. Use a damp cloth for cleaning.

19.This TV should never be placed near or over a radiator or heat resource. This TV should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to.

20.Do not place this TV on an unstable cart, stand, tripod, bracket, or table. The TV may fall, causing serious injury to someone, and serious damage to the appliance.

21.Do not attempt to service this TV by yourself because opening or removing covers may expose you to dangerous high voltage or other hazards. Refer all servicing to qualified service personnel.

22.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

23.WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation instructions.

24.To reduce the risk of electric shock, the grounding of center pin of plug must be maintained.

25.If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA NO.70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrodes. (See figure A)

ANTENNA

LEAD IN

WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

Preparation for Your New TV

Before Turning On TV

Check Accessories

Check the accessories that are packed with your TV.

REMOTE CONTROL AAA BATTERIES	TV STAND SCREWS
PART NO.: RE20QP80	SCREWS
	M4 x 12mm, 6pcs
	Part# RS01TM412H

	SCREWS
	M4 x 14mm, 4pcs
	Part# RS01PWA414HT
TV STAND BASE	TV STAND NECK
PICTURE
SOUND
DOCUMENTS
Quick Start Guide
LED LCD TV
User’s Manual

USER’S GUIDE QUICK START GUIDE PATENT CARD

Setup TV Table Stand

Please refer to TV Stand Installation guide in next page to carry out stand installing.

Select TV Location

Select a flat, stable table to place your TV set. Please follow the Safety Instructions when placing the TV.

Connection and Using

After placing your TV properly, you can connect the TV with power supply and cable components. For further information, see page 4 to page 5.

Note: Above accessories are subject to change without notice.

Please register your product at www.rca.com

Please keep your sales receipt and keep the record of the serial number and the date of purchase in order to receive warranty parts and service.

The serial number is located at the back of the TV.

Made for Today.

EPG (Electronic Program Guide)	8
OSD Menu Operations	8
Adjust the OSD Screen	8
Picture Menu	8
Sound Menu	8
Channel Menu	9
Parental Menu	9
Setup Menu	10
		Child Safety Guide
Others Menu	10
Frequently Asked Questions (FAQs)	11
Troubleshooting	11
V-Chip Rating Explanations	12
US V-Chip Rating System	12
Canadian English Rating System	12
Canadian French Rating System	12
Wall Mounting Unit Specification	13
USB Media Play	13
Product Specification	13

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Caution: To reduce the risk of electric shock, do not remove cover or back. No user-serviceable parts inside. Refer servicing to qualified service personnel.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product enclosure that may be of sufficient magnitude to consitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the TV.

	produce heat.
9.	Do not defeat the safety purpose of the polarized or grounding-type
	plug. A polarized plug has two blades with one wider than the other.
	A grounding-type plug has two blades and a third grounding prong.
	The wide blade or the third prong is provided for your safety. If the
	provided plug does not fit into your outlet, consult an electrician for
	replacement of the obsolete outlet.
10.	Protect the power cord from being walked on or pinched
	particularly at plugs, convenience receptacles, and the point where
	they exit from the apparatus.
11.	Only use attachments/accessories specified by the manufacturer.
12.	Use only with cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. A TV and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the TV and cart combination to overturn.

13. Unplug this apparatus during lightning storms or when unused for

long periods of time. For added protection for this TV receiver

during a lightning storm, or when it is left unused for long periods

of time, unplug it from the wall outlet and disconnect antenna or

cable system. This will prevent damage to the TV due to lightning

and power line surges.

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

ELECTRIC SERVICE	POWER SERVICE GROUNDING
EQUIPMENT	ELECTRODE SYSTEM
	(NEC ART 250, PARTH)

Figure A

Safety Strap

Caution: Pushing, pulling or climbing on the TV may cause the TV falling. Do not let chlidren climb or hang on the TV. Always place the TV on a sturdy, level, stable surface that can hold the weight of TV. And if possible, secure the TV according to the instruction below (Note: The fastening components such as screws are not supplied with TV).

Step one: Insert the M6 mounting screws into the upper two wall mounting screw holes and fasten them (Figure B).

Step two: Insert anchors to wall and connect the bolts and anchors with ropes or chains (Figure C).

Wall

M6 Screws

TV Stand Installation

TV LED46C45RQ is packaged with the TV stand separated from the cabinet. To setup the TV table stand, please carry out the installation according to the instructions below.

Step One

Place the TV faced down on a soft cloth or cushion to prevent the LED LCD panel from being damaged.

The LED LCD panel can be scratched easily, so please:

1. Choose an absolutely flat

surface to place the TV on.

2. Use soft cloth or cushion to

face the TV panel.

Do not put TV on the table directly.

Always unplug the AC cord first when installing/removing the stand.

Step Two

14. Refer all servicing to qualified service personnel. Servicing is

Take the neck. Please align the screw holes of the neck and the TV, and

Warranty Card 14 1

2

required when the apparatus has been damaged in any way, such

Figure B Figure C 3 then insert the 6 screws into the 6 holes on the neck and tighten them.