RCA P46920BL manual Sample Connections, TV and Stereo VCR, How to View Your VCR

Video (yellow)

Right Audio (red)

Left Audio (white)

Setup and Connections

Sample Connections

The following are sample connection scenarios which you may encounter when connecting components to your TV. Note: those components which offer an S-Video connection, such as DVD, VCR or Satellite Receivers, must match their S-Video connection with their audio INPUT connection.

Cables

You will use the following cable to make your connection:

Coaxial Cables: Carries the signal from the antenna or cable directly to the television or through a cablebox, as needed by your cable system.

Audio/Video Cables: Carries sound and video from the component to the TV.

S-Video Cable: Carries video from an S-Video capable component which provides best picture quality.

TV and Stereo VCR

CABLE, CABLE BOX, OR ANTENNA

Cautions:

Position cables to Avoid Audio Hum or Interference

•Insert all cables firmly into jacks.

•Place the audio/video cables to the sides of the TV’s back panel instead of straight down the middle.

•Try not to coil any twin-lead cables and keep them away from the audio/video cables.

Protect your components from Overheating

•Do not block ventilation holes in any of the components. Arrange the components so that air can circulate freely.

•Do not stack components.

•Allow adequate ventilation when placing your components in a stand.

•Place an amplifier on the top shelf of the stand so heated air rising from it will not flow around other components.

VCR
IN		IN FROM ANT CH3
		CH4
VIDEO	R AUDIO L	OUT TO TV
OUT

TV
	SPEAKER	+ RIGHT -	+ LEFT -
	SELECTION
	EXTERNAL INTERNAL
	SPEAKERS
	INPUT 2		S-VIDEO
INPUT 1	VIDEO	L—AUDIO—R
VIDEO			VCR
			CONTROL
R	R
AUDIO	AUDIO		CABLE/
L	L		ANTENNA
			INPUT
S-VIDEO	AUDIO OUTPUT

How to View Your VCR

To watch the VCR in this connection, press TV to put the remote control into TV mode, then press WHO•INPUT to scroll through the video input channels until you tune to VID1 input.

In the Interactive Setup section you can program the TV to automatically tune to the VID1 input channel when you turn on the VCR.

Most Audio/Video cables are combined into one cable with three

heads on each end.

Compared to the Basic Connection, using audio, video and

S-Video (if available) cables will enhance the sound and picture quality from a component.

We show individual

cables in these sample connections.

Either may be used, but you must be sure to connect Video to Video,

Right to Right and Left to Left.

7