RCA RC170I user manual Before you begin, Electrical power information, Plugging in for power

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Electrical power information

AC/DC adapter:

Input: 100 - 240 V AC, 50/60 Hz

Output: 8 V DC, 2.2A

“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

iPhone, iPod, iPod classic, iPod nano and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.

Before you begin

The first time you dock your iPhone or iPod touch, you’ll be prompted to download the free RCA N-hance App from the iTunes store. You are encouraged to download and install this app (right on your iPhone or iTouch)

in order to enjoy the wide variety of features which are available with

N-hance. Instructions on how to use the N-hance App can be found in the About section inside the app.

• App is for iPhone/iPod touch only (iOS 3.2 or higher).

•Note the N-hance App must be running in order for the dock to properly sync to your iPhone or iPod touch. Furthermore, the app must be running and visible for proper operation of all the N-hance features such as personalized alarms, weather, etc, etc. Launch the N-hance App by touching the N-hance icon on your iPhone or iPod touch either just before or just after docking.

•Note that the dock display will be turned off when the app is showing a clockface.

•Refer to the User Guide found within the N-hance App for more detailed information.

Plugging in for power

•Connect the supplied power adapter to the unit’s DC jack, and connect to a convenient wall outlet.

•Refer to the “Clock” section and follow the instructions to set the clock time.

Battery back-up operation

•This clock radio is equipped with a timekeeping system that is powered with 2 “AA” batteries (not included). The power failure protection circuit will not operate unless batteries are installed.

•When normal household power is interrupted, or AC line cord is unplugged, the batteries will power the clock radio to keep track of time and alarm settings programmed into memory.

•When battery backup is operating during a power interruption, the clock display will not light, however the alarm will function at the set time as long as the remaining battery power is adequate.

•Normal operation will resume after AC power is restored so you will not have to reset the time or the alarm.

To install or replace the batteries:

1.Remove battery compartment door (located at the bottom of the radio) by applying thumb pressure to the tab on battery door and then lift the door out and off the cabinet.

2.Insert or replace 2 AA batteries.

3.Replace the compartment door.

• It is recommended to replace the batteries at least once per year even if

no power failures have occurred.

•It is recommended to plug the unit for AC power while replacing batteries to avoid the loss of clock and wake time/ mode settings.

Power failure indicator

If back-up batteries are not installed or are too weak and AC power is disconnected for a short period of time, the time and alarm settings will be lost. After AC power is restored (reconnected), the Digital Display

will blink to indicate that power was interrupted and you should re-adjust the time and alarm settings.